Because the local echo is always enabled in the SerialTools application, the entered characters will be displayed twice. In the Serial Port field, select the Cypress USB-Serial UART device node created in step 1, as shown in Figure 1.įigure 1: Connecting the USB-UART Bridge in SerialToolsĬonfigure the UART parameters, such as baud rate, stop bits, data width, and parity.įor simple loopback tests, short the RXD and TXD pins of the USB-Serial device on the board.Ĭlick Connect to start communicating with the device. Works with cellular phones, PDA, Digital Cameras, Modems, or ISDN terminal adapters Support Microsoft Windows and Mac OS 8.6 or higher. SerialTools is a free application available in the Apple App Store. Install a standard terminal emulator, such as SerialTools, to test the UART functionality of the device. After the driver successfully binds, a device node is created as /dev/tty.usbmodem. The Mac CDC driver (AppleUSBCDC) automatically binds to the device. A Cypress USB-Serial Bridge Controller configured as Communication Device Class (CDC) UART will automatically bind to the Apple USB CDC driver, which is the CDC driver in Mac OS X.įollow these steps to test the CDC mode for the Cypress USB-UART LP Bridge on Mac OS:Ĭonnect the USB-Serial Bridge Controller to Mac.